![]() Set protocols bgp group BGP-to-R1 neighbor 1.1.1.1 peer-as 65001 Peer AS InPkt OutPkt OutQ Flaps Last Up/Dwn State|#Active/Received/Accepted/Damped.ġ.1.1.2 65002 5741 5740 0 1 5 let’s configure R2 end and commit the changes. Table Tot Paths Act Paths Suppressed History Damp State Pending It’s because remote end, still not configured and R1 actively trying to establish the session. Now, we will check bgp session summary by using “ run show bgp summary“. We will configure internal bgp (iBGP) in another article. Here, we are saying that, our BGP type is external, which means it’s eBGP. Set protocols bgp group BGP-to-R2 type external ![]() Set protocols bgp group BGP-to-R2 neighbor 1.1.1.2 peer-as 65002 In the second step, I will configure bgp session with remote end and commit the changes. Set routing-options autonomous-system 65002 Set routing-options autonomous-system 65001 In the first step, I will be announcing ASN and Router-IDs. My both interfaces are UP and i can ping Router R2, from R1. commitīelow, is my verification from R1 end. Set interfaces ge-0/0/1 unit 0 family inet address 172.16.0.1/24Ĭommit your configuration, and do basic check up. Set interfaces ge-0/0/0 unit 0 family inet address 1.1.1.2/30 Set interfaces ge-0/0/1 unit 0 family inet address 10.1.1.1/24 R2: ![]() Set interfaces ge-0/0/0 unit 0 family inet address 1.1.1.1/30 Let’s configure these by following below network topology.įirst of all, we will configure the IP addresses of the interface for both of the Routers as per the topology.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |